Cutting Speeds for Stainless Steel

Austenitic stainless (304, 316) work-hardens quickly, so the rules are: run slower, never let the tool dwell, and always take a real chip. Rubbing is the fastest way to ruin both the part and the cutter.

Convert SFM to RPM: RPM = (SFM × 3.82) / cutter diameter (in). Then feed rate (IPM) = RPM × chip load × flutes. Do it instantly with the Feeds & Speeds calculators.

Cutting speeds (SFM)

Operation HSS (SFM) Carbide (SFM)
Milling 40 – 60 150 – 300
Turning 50 – 70 200 – 350
Drilling 30 – 50 100 – 200

Recommended chip load

End mill diameter Chip load (in/tooth)
1/8 in 0.0004 – 0.0008
1/4 in 0.0008 – 0.0015
3/8 in 0.0012 – 0.0020
1/2 in 0.0015 – 0.0030
3/4 in 0.0020 – 0.0035
1 in 0.0025 – 0.0040

Starting points for general work. Defer to your tooling manufacturer and adjust for rigidity, coolant, depth of cut, and finish.

Tips

  • Never dwell or let the tool spin in place — stainless hardens under a rubbing edge.
  • Use sharp TiAlN-coated carbide, a rigid setup, and constant flood coolant.
  • Climb mill and commit to a real chip load; a light, timid cut hardens the surface.
  • If the work-hardened skin forms, get under it next pass rather than skimming the top.

See the full Feeds and Speeds Chart for every material side by side.

Why stainless is different

Austenitic stainless steels such as 304 and 316 work harden quickly, which means that the surface becomes harder when the tool rubs instead of cutting. That is why the tool must take a real chip, never dwell, and keep moving. A dull tool or too light a feed makes the problem worse.

Practical tips

Use sharp, rigid tooling, a constant, solid feed, and plenty of coolant to carry away heat, since stainless conducts heat poorly and builds it up at the cutting edge. Run slower than for carbon steel, and avoid stopping the tool in the cut. If the surface turns glassy or the tool squeals, it is likely work hardened, so reduce the speed and increase the feed.

Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.