How to Make Espresso

Espresso forces hot water through finely ground coffee under pressure. A good shot is balanced and sweet with a layer of crema on top.

What you need

An espresso machine, a burr grinder, and fresh beans. A standard double shot doses about 18 to 20 g of finely ground coffee into the basket.

Pulling a shot

  1. Dose 18 to 20 g of fine coffee into the portafilter.
  2. Distribute evenly and tamp level with firm pressure.
  3. Lock the portafilter into the machine and start immediately.
  4. Aim for roughly double the dose out (36 to 40 g) in 25 to 30 seconds.
  5. Watch the flow: it should start dark and slow, then turn honey-like.

Dialing it in

If the shot runs too fast and tastes sour, grind finer. If it runs too slow and tastes bitter, grind coarser. Change one thing at a time.

A 1:2 ratio in 25 to 30 seconds. Target about twice the dose in weight out of the basket over 25 to 30 seconds. That ratio and time is the backbone of a balanced shot.

See the Espresso Yield Calculator and the Espresso Extraction Chart.

Dialing in a shot

A common starting point is to put 18 to 20 grams of ground coffee in the basket and aim for about twice that weight of liquid espresso in the cup in roughly 25 to 30 seconds. Weigh the dose and the yield on a scale, and use the time as a guide. If the shot runs fast and tastes sour and thin, grind finer, and if it runs slowly and tastes bitter, grind coarser.

Habits that help

Distribute the grounds evenly and tamp level, since an uneven puck lets water run through the weak spots, called channeling, and ruins the shot. Use fresh beans, since crema comes from gas in freshly roasted coffee. Keep the machine warm, purge the group head before brewing, and clean the basket and screen regularly because old oils make the coffee taste harsh.

Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.