Feed per Revolution Calculator

CORE CNC

Feed per revolution converts spindle RPM and a chosen feed-per-rev value into the linear feed rate (IPM) used for turning, drilling, and reaming operations.

Feed Rate—
Feed Rate (IPM) = RPM × Feed per Revolution. Used for turning, drilling, and reaming where feed is specified per spindle revolution rather than per tooth.

How it works

Unlike milling, where feed is programmed per tooth across multiple flutes, single-point turning tools and most drills and reamers are programmed per spindle revolution. This ties the feed rate directly to how far the tool advances each time the spindle turns once, regardless of the tool’s cutting-edge count. A quick way to sanity-check the result: feed rate in IPM divided by RPM should always equal back the feed-per-revolution value you started with.

FAQ

Is feed per revolution the same as chip load? Not quite. Chip load usually refers to feed per tooth on multi-flute milling tools, while feed per revolution is the equivalent concept for single-edge or per-revolution-fed operations like turning and drilling.

Related Guides

CNC Calculators · Turning Feed Calculator · Drill Feed Calculator

Where feed per revolution is used

Turning, drilling, boring, and reaming are normally programmed in distance per spindle revolution, because the tool engages the work once per turn no matter how fast the spindle runs. Milling works differently, using feed per tooth. This calculator converts a feed per revolution value and your spindle speed into inches per minute for controls or setups that want a feed per minute number.

Choosing the value

Roughing passes in turning take a heavier feed per revolution, while finishing passes use a light feed to leave a better surface. Insert nose radius also sets a practical ceiling, since a feed that is too large relative to the radius leaves visible ridges on the finished surface.

Practical tips

When spindle speed changes, as it does under constant surface speed, feed per minute changes with it while feed per revolution stays fixed. Many lathe controls handle this automatically when feed per revolution mode is active, so check which mode your program is in before comparing numbers.

Spotted an error or have a suggestion for this calculator? Let us know →
Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.