Router Speed and Feed Calculator

CNC ROUTER

Get spindle speed and feed rate for a CNC router bit cutting wood, MDF, or plastic, from bit diameter, target surface speed, chip load, and flute count.

–
Spindle Speed (RPM)
–
Feed Rate (in/min)

RPM = (SFM x 3.82) / D. Feed = RPM x chip load x flutes. Wood and plastics tolerate much higher chip loads than metal, so use chip load values meant for the material, not metal cutting charts.

How it works

Router spindles are usually fixed-speed or limited to a narrow RPM range, so it is common to pick the closest available RPM first and then solve for the feed rate that delivers the chip load you want at that speed.

FAQ

My router only has a few speed settings, now what? Plug in the closest RPM your machine actually offers instead of the calculated one, then adjust the feed rate until the resulting chip load matches your target.

Related Guides

CNC Calculators · SFM Calculator · Chip Load Calculator

How the speed and feed are linked

A router bit needs the right spindle speed and the right feed rate together. Spindle speed comes from the target surface speed and the bit diameter, and feed rate comes from that speed, the flute count, and the chip load. Getting both from one calculator keeps the numbers consistent.

Choosing the inputs

Softer woods and plastics tolerate a higher surface speed than dense hardwoods, and chip load is chosen by material and bit type. A bit with more flutes can feed faster at the same chip load, but also has less space to clear chips, so deep cuts in gummy materials often use fewer flutes.

Practical tips

Many routers have limited speed settings, so pick the closest one and adjust the feed to restore the chip load. Burn marks usually mean too low a feed or too high a speed, while rough, torn edges point to too high a feed or a dull bit. Adjust in small steps and check the chips as you go.

Spotted an error or have a suggestion for this calculator? Let us know →
Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.