Bar Stock Length Calculator

LATHE

Work out how many parts a length of bar stock will yield once facing and parting allowances are accounted for, plus the leftover remnant.

–
Parts per Bar
–
Leftover Remnant (in)

Parts per bar = floor((bar length – facing allowance) / (part length + parting width)). Remnant = what is left after that many parts are cut.

How it works

Every part consumes its own length plus the width of metal lost to the parting tool, and the very first face cut takes a small allowance off the end of the bar. Dividing total usable length by that per-part consumption gives a real part count instead of an optimistic estimate that ignores kerf loss.

FAQ

Should I count the remnant as a usable part? Only if it is long enough to safely hold in the chuck or collet with enough material left to face and part off again.

Related Guides

CNC Calculators · Material Cost Calculator · Cutting Time Calculator

Planning bar stock use

When parts are turned from bar, every part uses its finished length plus the width of the cutoff tool and any material faced off the end. Ignoring those allowances makes it look as though more parts fit than really do, and a bar that seemed long enough runs short near the end of a job.

How the count works

The calculator adds the finished length, the parting width, and the facing allowance to find the stock used per part, then divides the bar length by that to get the number of parts and the leftover remnant. The remnant tells you whether it is worth keeping or whether a different bar length wastes less.

Practical tips

Remember that the last piece usually cannot be machined all the way, since the chuck or bar feeder needs some bar to grip. Subtract that length from the bar before counting. Check a few standard bar lengths for the one that leaves the smallest remnant, which saves material on larger runs.

Spotted an error or have a suggestion for this calculator? Let us know →
Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.