Corner Feed Reduction Calculator

MILLING

Cutting around a corner pulls the tool sideways, and the machine cannot apply infinite acceleration to follow it. This estimates the maximum feed rate that keeps that cornering force within the machine limit you set.

–
Max Safe Cornering Feed (in/min)

Max feed = sqrt(acceleration x corner radius), using 1g = 386.4 in/sec^2, converted to in/min. Sharper corners and lower acceleration limits both force a slower feed.

How it works

Following a curved path at constant speed requires centripetal acceleration equal to feed squared divided by radius. Setting that equal to the machine maximum lateral acceleration and solving for feed gives the fastest speed the control can hold through the corner without losing accuracy or overshooting.

FAQ

What if the corner is perfectly sharp with no radius? Treat it as the smallest radius your control can resolve, such as a corner rounding or look-ahead tolerance value, since a true zero radius implies an instant stop.

Related Guides

CNC Calculators · Cutting Time Calculator · Circular Interpolation Calculator

Why corners limit the feed rate

A machine cannot change direction instantly. When a tool follows a tight corner or small arc, the axes must accelerate sideways, and there is a limit to the acceleration the drives and structure can deliver. If the programmed feed is higher than that limit allows, the control slows down on its own or the tool leaves the intended path and cuts the corner short.

What the estimate shows

This calculator estimates the highest feed that keeps the cornering force within the machine acceleration limit for a given corner radius. Smaller radii and lower machine acceleration both reduce the feed that can be held through the corner.

Practical tips

Small features cut at the full programmed feed often take much longer than the cycle time estimate suggests, because the machine is slowing through every corner. Using larger corner radii where the design allows, or a toolpath that rounds the corners, keeps the machine moving and gives a better finish.

Spotted an error or have a suggestion for this calculator? Let us know →
Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.