End Mill Selection Chart

Picking an end mill comes down to three choices: how many flutes, what shape, and which coating. Match those to your material and operation and most feeds-and-speeds problems solve themselves.

Flute count

Flutes Best use
2 flute Aluminum and plastics; maximum chip clearance, good for slotting
3 flute Aluminum with a better finish while still clearing chips
4 flute Steel and stainless; more cutting edges, better finish and rigidity
5–6+ flute Finishing passes and hard materials with light radial cuts

End mill type

Type Use
Square end General milling, slots, shoulders, flat floors
Ball nose 3D contouring, fillets, curved surfaces
Corner radius (bull nose) Tougher edge for roughing and semi-finish; avoids chipping
Roughing (hog) Fast stock removal; serrated edge breaks chips
Chamfer Edge breaks, deburring, countersinks

Suggested setup by material

Material Suggested tool
Aluminum 2–3 flute, uncoated or ZrN, high helix (35–45°)
Mild steel 4 flute, TiAlN, ~30° helix, flood coolant
Stainless 4–5 flute, TiAlN or AlTiN, variable helix, rigid setup
Titanium Low helix, AlTiN, light radial cuts, very rigid setup
Plastics 2 flute, uncoated, polished flutes, high RPM

More flutes give a better finish but less chip room; softer, gummier materials need fewer flutes so chips can escape.

Pair this with the Tool Coating Comparison and the Feeds and Speeds Chart.

Flutes, shape, and coating

Fewer flutes give more room for chips, which suits aluminum and slotting, while more flutes give a smoother finish and stronger cutter body, which suits steels and finishing. Square cutters make flat bottoms, ball cutters make curved surfaces, and corner radius cutters are stronger at the tip. Coatings reduce wear and heat in harder materials.

Matching the cutter

Choose the cutter for the material first, then the operation. Aluminum wants sharp, polished cutters, often uncoated or with a slick coating, while steels and stainless benefit from coated carbide. Use the shortest cutter that reaches the feature to keep the setup rigid, and check that the shank fits your holder. Tool makers publish detailed recommendations for each cutter.

Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.