Helical Interpolation Calculator

MILLING

When boring a hole larger than the tool by helical interpolation, the tool center follows a smaller circle than the cutting edge. This finds the center path radius and the feed rate to program so the cutting edge runs at your intended feed.

–
Center Path Radius (in)
–
Programmed Feed Rate (in/min)

Center path radius = (hole diameter – tool diameter) / 2. Programmed feed = desired edge feed x (center radius / hole radius).

How it works

G-code drives the tool center, not the cutting edge. For an internal hole, the center traces a smaller circle than the edge, so programming the edge feed rate directly into the control would run the edge faster than intended. Scaling by the radius ratio keeps the edge at the speed you actually want.

FAQ

Does this apply to circular pockets too? Yes, any time a tool is interpolating in a circle smaller than the finished feature, the same center-to-edge radius ratio applies.

Related Guides

CNC Calculators · Circular Interpolation Calculator · SFM Calculator

Why the tool path is smaller than the hole

When a hole is cut by helical interpolation, the tool moves around the inside of the hole on a circle while moving down. Because the tool has its own diameter, the circle that the tool center follows is smaller than the finished hole by the tool diameter. This calculator finds that center path radius.

Programmed feed versus edge feed

The cutting edge travels on a larger circle than the tool center, so feed measured at the edge is higher than feed measured at the center. The calculator finds the feed rate to program so the edge sees the intended chip load, which matters most when the tool is large relative to the hole.

Practical tips

Helical interpolation lets one end mill cut many hole sizes and avoids buying a drill for each one. Keep the helix pitch moderate so chips clear, finish the bore with a light spring pass, and check that the tool is small enough to leave room for chips to escape.

Spotted an error or have a suggestion for this calculator? Let us know →
Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.