Aluminum alloys like 6061 and 7075 machine fast and clean. The limiting factor is usually chip evacuation and built-up edge, not hardness, so high surface speeds with sharp tools work best.
Cutting speeds (SFM)
| Operation | HSS (SFM) | Carbide (SFM) |
|---|---|---|
| Milling | 250 – 300 | 600 – 1200 |
| Turning | 300 – 400 | 500 – 1000 |
| Drilling | 200 – 300 | 400 – 600 |
Recommended chip load
| End mill diameter | Chip load (in/tooth) |
|---|---|
| 1/8 in | 0.0010 – 0.0020 |
| 1/4 in | 0.0020 – 0.0040 |
| 3/8 in | 0.0030 – 0.0050 |
| 1/2 in | 0.0040 – 0.0060 |
| 3/4 in | 0.0050 – 0.0080 |
| 1 in | 0.0060 – 0.0100 |
Starting points for general work. Defer to your tooling manufacturer and adjust for rigidity, coolant, depth of cut, and finish.
Tips
- Use 2–3 flute end mills so chips clear instead of packing and welding.
- Sharp, polished uncoated or ZrN / TiB2 tools resist aluminum sticking; avoid TiN.
- Climb mill and keep air blast or flood coolant on the cut to prevent built-up edge.
- If you see a dull, smeared finish, raise RPM or add coolant — that is built-up edge.
See the full Feeds and Speeds Chart for every material side by side.
Aluminum runs fast
Aluminum can be cut at much higher surface speeds than steel, and the limit is often the maximum speed of the spindle, not the material. A small cutter may never reach the recommended surface speed on a machine with a modest top speed, in which case run at the maximum and adjust the feed to keep the chip load right.
Preventing problems
Sticking and chip welding are the main issues, so use sharp, polished cutters, good chip evacuation, and coolant or an air blast. Different alloys behave differently, since free machining grades cut cleaner than very soft or gummy ones. Always check that the workholding can handle the speed before running a part at high spindle speeds.
