Driver Efficiency Table

An LED driver loses some power as heat. Its efficiency affects total system energy use and heat load. This chart compares driver types.

Driver type Typical efficiency
Linear (resistive) 50 to 70%
Magnetic 80 to 85%
Electronic constant-voltage 85 to 90%
Electronic constant-current 88 to 92%
High-end programmable 90 to 94%
Load it properly. Driver efficiency falls off below about 20% of rated load. Size the driver so the fixtures use most of its capacity.

See the LED Driver Calculator and 0-10V Dimming Guide.

Where the losses go

An LED driver converts line power into the controlled current or voltage that the LEDs need, and some power is lost as heat in the process. A driver that is 90 percent efficient and supplies 36 watts to the LEDs draws 40 watts from the supply, so 4 watts are lost. Higher efficiency means less wasted energy and less heat to remove.

Choosing a driver

Efficiency changes with the load, and it is often lower when the driver is dimmed or lightly loaded, so check the figure at your operating point. A driver that runs cooler also tends to last longer, since heat shortens the life of its electronic parts. When you compare fixtures, look at the efficacy of the whole system, including the driver, and not only the LEDs.

Efficiency in the system

Driver efficiency is one part of the efficacy of the whole fixture. A fixture with efficient LEDs and a poor driver still wastes power, and the lost power turns into heat inside the housing. Keep an eye on the efficiency figure on the datasheet and compare it at the actual load and temperature the fixture will see.

Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.