Coolant Mixture Chart

Engine coolant is a blend of antifreeze (ethylene glycol) and water. The ratio sets how cold it can get before freezing and how hot before boiling. A 50/50 mix is the all-around standard; richer mixes buy more cold protection up to a limit.

Antifreeze : Water Freeze protection Boil protection (15 psi cap)
40 : 60 -12 °F 259 °F
50 : 50 -34 °F 265 °F
60 : 40 -62 °F 270 °F
70 : 30 -84 °F 276 °F
Stay between 40% and 70% antifreeze. Below 40% loses freeze and corrosion protection; above 70% actually protects less and transfers heat worse. Use distilled water to avoid mineral deposits.

Use the coolant type your manufacturer specifies (IAT, OAT, HOAT) — mixing chemistries can gel. Pre-mixed coolant is already 50/50.

FAQ

Can I use a stronger coolant mixture than recommended for extra protection? Not indefinitely — coolant mixtures stronger than roughly 70 percent antifreeze actually lose freeze protection and cooling efficiency, since pure antifreeze conducts heat less effectively than a proper water-antifreeze blend. Stick to the manufacturer’s recommended ratio, typically 50/50.

Mix a batch with the Antifreeze Dilution calculator in the automotive calculators.

Getting the Mix Right

More antifreeze isn’t always better — past roughly 70% ethylene glycol, freeze protection actually gets worse, not better, because pure glycol freezes at a higher temperature than a properly diluted mix. Straight, undiluted antifreeze also transfers heat less efficiently than a water mix, so running too rich can leave an engine running hotter than it should.

Use distilled water, not tap water, when mixing coolant — the minerals in tap water build up as scale inside the radiator and water jackets over time, gradually reducing cooling efficiency and clogging narrow passages.

Rather than guessing a ratio, a coolant refractometer (or the cheaper float-style hydrometer) reads the actual freeze and boil protection of a mix in seconds, which is the only reliable way to know what’s really in a system that’s been topped off over time with whatever was on hand.

Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.