TRIAC Dimming Guide

TRIAC dimming chops the AC line waveform to reduce power, the same phase-cut method used by classic wall dimmers. It is common in residential retrofits.

Aspect Detail
Method Phase-cut on the line voltage
Forward phase Leading edge, older dimmers
Reverse phase Trailing edge, better for LED
Needs Dimmable driver + compatible dimmer
Watch for Flicker, buzz, min-load issues

Compatibility is everything

TRIAC was designed for resistive incandescent loads. LEDs draw far less, so a mismatched dimmer can flicker, buzz, or fail to dim smoothly at the low end.

Trailing-edge (reverse phase) dimmers generally work better with LED drivers than older leading-edge units.

Check the compatibility list. Manufacturers publish tested dimmer-driver pairings. Using a listed combination is the surest way to avoid flicker and dropout.

See the 0-10V Dimming Guide and the Control Protocol Comparison.

How TRIAC dimmers work

A TRIAC dimmer cuts a portion of each cycle of the AC voltage, which lowers the average power reaching the lamp. This phase cut method is what most standard wall dimmers use, and it is simple and inexpensive. It was designed for incandescent bulbs, so LED lamps and drivers need to be designed to work with it.

Avoiding problems

Mismatches between dimmers and LED loads cause flicker, buzzing, a limited dimming range, or lamps that will not turn off completely. LEDs draw little power, so a dimmer may need a minimum load to work properly. Check the dimmer and lamp compatibility lists from the manufacturers, and use trailing edge dimmers for electronic loads, which are usually quieter and smoother. Do not put more lamps on a dimmer than its rating allows.

Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.