Runout Effect on Chip Load Calculator

TOOLING

Tool runout means one flute does almost all the cutting while the others barely engage. This finds the worst-case chip load each flute is really seeing.

–
Dominant Tooth Load (in)
–
Trailing Tooth Load (in)

Dominant tooth load = programmed chip load + runout. Trailing tooth load = programmed chip load – runout, floored at zero. Both come from the same programmed feed, runout just redistributes the work unevenly between flutes.

How it works

If a tool runs even a couple thousandths off center, one flute sweeps a wider radius and takes nearly all the chip load while the opposite flute can end up rubbing instead of cutting. This shortens tool life and roughens the finish even though the programmed feed per tooth looks fine on paper.

FAQ

How much runout is acceptable? Keeping TIR under roughly 10 percent of the programmed chip load keeps the load split close to even, anything beyond that and tool life and finish start to suffer.

Related Guides

CNC Calculators · Chip Load Calculator · Tool Life Estimator

Why runout makes one flute do the work

No tool and holder combination spins perfectly true. Runout, measured as total indicator reading, means the tool axis wobbles slightly, so one flute sits farther out than the rest and takes a heavier cut while the others barely touch the work. The chip load printed on the program is an average, but the dominant tooth sees more than that.

What the calculator shows

It combines the programmed chip load per tooth with the runout to estimate the worst-case chip load on the leading flute. The effect is largest on small chip loads, where a few thousandths of runout can double the load on one tooth and shorten tool life quickly.

Practical tips

Clean the taper and collet, use a quality holder, and check runout with an indicator, especially for small end mills and finishing passes. Shrink fit and hydraulic holders usually run truer than standard collets. If runout cannot be improved, reduce the feed to protect the dominant tooth.

Spotted an error or have a suggestion for this calculator? Let us know →
Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.