Setup & Workholding Calculators
Vise jaws, work offsets, tool length offsets, clamping forces, and setup documentation.
Workholding math only protects a part if the numbers feed into a decision you actually make at the machine — clamping force is only useful compared against the cutting forces the job will generate, and a vise jaw width calculation only matters if you check it before, not after, you’ve already cut custom soft jaws.
Work offsets and tool length offsets should be verified with a test move at a safe height before the first real cut on a new setup, especially after swapping fixtures or vises — a wrong offset is one of the few setup mistakes that can crash a spindle into a part or fixture within seconds.
For repeat jobs, write down the specific offsets, jaw settings, and fixture orientation once they’re proven, rather than recalculating from scratch each time — setup documentation is what turns a one-off calculation into a repeatable process the next operator can follow.
