Parting-Off Time Calculator

LATHE

Parting-off time estimates how long it takes to cut through stock using a parting (cut-off) tool, based on the radial distance the tool must travel and the parting feed rate.

Parting Travel (Radius)—
Cycle Time—
Travel = (Diameter – Bore Diameter) / 2. Time = Travel / Feed Rate.

How it works

The parting tool travels from the outer diameter toward center, or toward a hollow bore/bar diameter on tube stock, so travel distance is half the difference between stock and bore diameter, not the full diameter. Parting feeds run slower than normal turning feeds because the tool is narrow, has poor chip clearance, and is prone to grabbing if fed too aggressively.

FAQ

Why is my parting tool grabbing or breaking? Common causes are feed rate too high for the tool width, excessive tool overhang, inadequate chip evacuation, or tool geometry not matching the material. Slowing the feed rate near the center, where surface speed drops, often helps.

Related Guides

CNC Calculators · OD Turning Time Calculator · ID Boring Time Calculator

Where parting-off time goes

Cutting a finished part from bar stock is a short operation, but it repeats on every part in a production run, so even small savings add up. The time is mostly the distance the parting tool must travel divided by its feed rate, and that distance depends on whether the stock is solid or hollow.

Solid bar and tube

For a solid bar the tool travels the full radius to reach the center. For tube or a bored part, it only needs to travel from the outer diameter to the inner diameter, which is why entering the bore diameter shortens the time. The calculator uses half the difference between the two diameters as the travel.

Practical tips

Many shops slow the feed near the center, where the cutting speed drops and the remaining stub can snap off, so real cycle time runs a little longer than the simple estimate. Keep the parting blade stickout short, aim coolant at the cut, and clear chips so they do not pack in the groove.

Spotted an error or have a suggestion for this calculator? Let us know →
Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.