Turning feed rate converts spindle RPM and a chosen feed per revolution into the linear feed rate (IPM) the lathe carriage moves during a cut.
How it works
Lathe feed is programmed per spindle revolution rather than per tooth because a turning tool has a single continuous cutting edge, not multiple flutes like a mill. Feed per revolution is chosen based on tool nose radius, desired surface finish, and material; finer feeds leave a smoother finish but take longer per pass. Doubling RPM at a fixed feed per revolution doubles the resulting feed rate in inches per minute, which is why feed per revolution, not feed rate directly, is the value most machinability data and tooling charts are built around.
FAQ
What feed per revolution should I start with? For general roughing in steel with a standard-radius insert, 0.008 to 0.015 in/rev is a common starting range; finishing passes often drop to 0.002 to 0.006 in/rev for a better surface finish.
Related Guides
CNC Calculators · Turning RPM Calculator · Feed per Revolution Calculator
Feed Rate Isn’t Constant Under Constant Surface Speed
With constant surface speed control (G96) active, the spindle’s RPM rises and falls automatically as the cutting diameter changes to hold the same SFM. Since feed rate here is just RPM times feed per revolution, that means the actual IPM feed rate drifts across a facing cut or a taper even when the programmed feed-per-rev value never changes — something worth watching on a part with a big diameter swing.
Nose Radius Sets the Practical Ceiling
Pushing feed per revolution higher leaves a deeper scallop, or cusp, between each pass, and a larger feed-per-rev value needs a proportionally larger tool nose radius to keep that cusp — and the resulting surface finish — the same. That’s why a sharp, small-radius finishing insert is paired with a conservative feed, while a tougher, larger-radius roughing insert can run a much higher feed per revolution for the same finish-quality trade-off.
Roughing and Finishing Want Different Priorities
A roughing pass is usually programmed at the highest feed per revolution the tool and machine can tolerate, because the resulting rough surface gets removed by the finishing pass anyway. The finishing pass instead drops feed per revolution specifically to buy surface finish, not speed — it’s the one place on the part where a slower feed is the entire point rather than a compromise.
