0-10V is a simple analog dimming standard: a low-voltage control signal tells the driver how bright to run, from 0 volts (minimum) to 10 volts (full output).
| Aspect | Detail |
|---|---|
| Signal | 0 V min to 10 V full |
| Wiring | Two extra low-voltage control wires |
| Control | Zone-based, not per-fixture |
| Type | Current sinking (standard) |
| Min level | Varies by driver, often 1 to 10% |
Strengths and limits
0-10V is inexpensive and reliable, ideal for dimming whole zones together. Its weakness is that it cannot address fixtures individually — every light on the loop dims as one.
The minimum dim level depends on the driver, so check the data sheet if you need to dim very low.
See the DALI Dimming Guide and the Control Protocol Comparison.
A separate control signal
The 0 to 10 volt method uses a pair of low voltage control wires that run to the driver, separate from the power wires. A signal of 10 volts gives full light, and the light falls as the voltage drops toward 1 volt, which is the minimum level. It is common in commercial buildings and is smooth and free of flicker, since it does not chop the line voltage.
Installation notes
The control wiring is low voltage and polarity matters, so connect the positive and negative wires to match the driver. Keep the control wires away from line voltage, follow the local rules for the wiring class, and check that the dimmer and the driver are compatible, since drivers vary in how they behave near the bottom of the range. Some systems need a relay to turn the lights fully off, because many drivers dim to a minimum level instead.
