End Mill Diameter Chart

Standard end mill diameters in fractional inch and metric, with decimal and millimeter equivalents. Use it to match a cutter to a feature and to convert between systems.

Fractional inch

Diameter Decimal (in) mm
1/16 in 0.0625 1.59
3/32 in 0.0938 2.38
1/8 in 0.1250 3.17
5/32 in 0.1563 3.97
3/16 in 0.1875 4.76
1/4 in 0.2500 6.35
5/16 in 0.3125 7.94
3/8 in 0.3750 9.52
1/2 in 0.5000 12.70
5/8 in 0.6250 15.88
3/4 in 0.7500 19.05
1 in 1.0000 25.40

Metric

Diameter Inch (in)
1 mm 0.0394
2 mm 0.0787
3 mm 0.1181
4 mm 0.1575
5 mm 0.1969
6 mm 0.2362
8 mm 0.3150
10 mm 0.3937
12 mm 0.4724

FAQ

Why does end mill diameter selection matter beyond just fitting the feature size? Larger diameters are stiffer and can run more aggressive parameters, but they also can’t reach small internal corners or narrow slots, so diameter selection is a balance between rigidity and access to the smallest feature in the part.

The most common sizes; many shops stock these plus reduced-shank and undersize cutters. Convert any size with the Unit Conversion Calculator.

Fractional and metric sizes

Fractional inch and metric end mills are made in standard series that do not line up exactly. A half inch cutter is 12.7 millimeters, which is not the same as a 12 millimeter or a 13 millimeter tool, so pick the one the feature is dimensioned for. The chart gives the decimal and millimeter equivalents to make comparing straightforward.

Picking a diameter

Use the largest cutter that fits the feature, since a bigger tool is stiffer and removes material faster. The diameter must also leave room for chips and for the inside corners of a pocket, which can be no sharper than the tool radius. Check the shank size against your collet or holder, and measure an important tool with a micrometer rather than trusting the nominal size.

Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.