4140 Steel Machining Data

4140 is a chromium-molybdenum alloy steel valued for strength and toughness. Machine it in the annealed or pre-hardened (HT) condition; fully hardened 4140 needs much slower speeds or grinding.

Key properties

Property Typical value
Density 0.284 lb/in³ (7.85 g/cm³)
Hardness ~197 HB annealed
Tensile strength ~95,000–120,000 psi
Machinability Fair
Composition Fe with Cr and Mo

Cutting speeds

Operation HSS (SFM) Carbide (SFM)
Milling 50 – 80 200 – 350
Turning 60 – 90 250 – 450
Drilling 40 – 70 150 – 280
Convert to RPM: RPM = (SFM × 3.82) / cutter diameter. Use the Feeds & Speeds calculators.

Tooling and tips

  • Use TiAlN carbide, flood coolant, and a very rigid setup.
  • Pre-hardened (28–32 HRC) stock machines fine; over ~40 HRC, slow right down.
  • Maintain feed pressure — rubbing glazes the surface and burns the edge.

FAQ

Should 4140 be machined in the annealed or hardened state? Machining is far easier and tool life much longer in the annealed or normalized condition. If higher hardness is required in the final part, most shops rough machine soft, heat treat, then finish machine or grind to final dimensions.

See Cutting Speeds for Steel and the full Feeds and Speeds Chart.

Where 4140 Shows Up

4140’s strength-to-cost ratio makes it a go-to for shafts, gears, axles, high-strength fasteners, and oilfield tooling — parts that need to survive repeated stress without the expense of a more exotic alloy. It is often sold pre-hardened and tempered (the “HT” or “PH” condition) specifically so shops can skip in-house heat treatment and still get a useful strength level.

Why 28–32 HRC is the sweet spot. That pre-hardened range balances strength against machinability — hard enough to need little further heat treatment for most applications, but soft enough to cut with standard carbide tooling. Pushing much past 40 HRC moves 4140 out of normal machining territory and into grinding, which is why fully hardened stock is worth avoiding unless grinding is already part of the plan.

Scroll to Top

The calculators and tools on Formula Factory are provided for general guidance and informational purposes only. Results are estimates based on standard formulas and the values you enter — they do not constitute professional engineering, electrical, or architectural advice. Always verify calculations with a qualified professional before making decisions for any safety-critical, code-compliance, or commercial application. Formula Factory makes no representations or warranties as to the accuracy or completeness of any result, and accepts no liability for errors, omissions, or any outcomes arising from reliance on this information.